We recommend having regular servicing to maintain an efficient system, when you have the boiler serviced for example to check inhibitor levels are still ok, no air locks in the system causing poor performance. With regular preventative maintenance, you will have no problems of breakdown
Underfloor heating
What Makes the Rapid Response® Heating System Low Carbon?
The responsive use and lower energy requirements to run the Rapid Response® heating system make it a low carbon solution that’s compatible with current heating technology like gas/oil boilers; as well as working efficiently with alternative fuels of the future like hydrogen boilers and air & ground source heat pumps.
What if there’s a problem?
Our experts are more than happy to offer FREE advice before, during and after your system has been installed – just call or email us. Rest assured though that all of our components carry long guarantees and are backed up with a £10M Product Liability insurance with AXA.
Is water floor heating hard to install?
Not at all! Wunda’s floor heating systems have been developed with the confident DIYer in mind, being able to lay the pipe and panels, leaving final commissioning to the professionals. If you’re extending or renovating, even simpler would be to make use of the builders already on-site and get them to install it for you.
Can I mix radiators and floor heating?
Floor heating and radiators happily work in conjunction with one another, to achieve this you will need to ‘T’ off from your boiler primaries, so one set of flow and return will go towards your radiators and the other to your floor heating system. Any competent plumber can easily do this work for you.
What’s the difference between electric and water based floor heating?
Electric has much higher running costs in comparison to water based systems making it suitable for smaller areas such as en suites but not for larger living areas and whole homes. For open plan kitchen and family areas, water based systems are more economic costing up to 65% less to run than electric.
What finishes can be used with floor heating?
Most floor finishes can be used with floor heating, Wunda developed Rapid Response®, high density boards to support heavier floor finishes such as marble and stone tiles. These boards are independently approved by leading tile adhesive manufacturers to be laid directly on top without the need for an intermediary layer that other, less dense, boards
Do I need to install floor heating in my whole house?
No, most users of floor heating install on the ground floor and combine the system with radiators upstairs – but you can install throughout the whole house if you wish.
Can I run floor heating off my current boiler and pump?
Absolutely, water based floor heating runs at lower temperatures, normally 35°C – 55°C, which is about half of what radiators run at. Water based floor heating is future proof and can be run from any heat source including heat pumps.
How does water underfloor heating work?
Warm water is pumped from the heat source to the manifold. If the floor heating requires warm water, the thermostatic valve will open allowing heated water into the manifold. From the manifold, heated water is pumped around the floor heating pipes, returning to the manifold and then either released back to the boiler/heat source via
